Stair Mounting Kit

Available in Slate or White



Qdos Advantages

• A universal and flexible solution for gate installation on banisters and spindles.

• Prevents damage to your woodwork by eliminating the need to screw into your banister.

• Works with both Hardware and Pressure mount gates.

• Works with all brands of gates.

• Available in Slate or White to compliment most gates.

• Fits square banisters up to 4” x 4” (10 x 10 cm), or round banisters up to 5” (12.7 cm) in diameter.

• Maximum gate installation height 34” (86 cm)

Stair Mounting Kit FAQs

Yes. The Stair Mounting Kit will work on banister to banister installation situations. You will need one kit for each banister. Remember each kit you use reduces the opening by 1.5" (38 mm).
34.25” (87 cm) long by 1 7/8" (4.75 cm) wide by .75" (2 cm) inches thick. The max installation point for a gate to "fit" the Stair Mounting Kit is 34", meaning that the top of where a gate mounts can't be above this point.
Yes. the Stair Mounting Kit can be used on any brand of gate.
The Stair Mounting Kit comes in White or Slate which matches the Qdos gates and compliments many other gates.
Only if it is at least 2"(4.5 cm) inches in diameter. If you are looking to install a Qdos Pressure Mount gate, you might be able to use the Y-Spindles on your metal banister.
The maximum gate installation height is 34”. This means that the top of the hardware attaching the gate to the Stair Mounting Kit can't be above 34".
No – the Stair Mounting Kit has heavy duty nylon straps which wrap around your banisters protecting your precious woodwork – so no need to screw into it.
Yes. The Stair Mounting Kit can be used with either pressure or hardware gates. Remember we recommend never using ANY pressure mounted gate at the TOP of the stairs due to the inherent trip hazard.
The Top Bracket needs to be no more than 3” from the top of the wooden board and the Bottom Bracket needs to be between 2 - 4” from the bottom of the wooden board.
It needs to be at least 2" (5 cm) diameter for round banisters OR 2.5" (4.5 cm) square banister. You can also install the Stair Mounting Kit between two spindles. If the banister is smaller than these measurements and you are looking to install a Qdos Pressure Mount gate then, you might be able to use the Y-Spindles
Back to Gate Accessories